FSL-CA★★★ CHAMFER | floor saw blade | 350x10x16 (2pc)
Item No. DFS0350-CHAM-01
Loading
- 2-part Chamfer diamond blade for bevelling concrete, asphalt and green concrete
- Not designed to perform cuts but to bevel existing cuts only
- The ideal procedure is to pre-cut with a standard 3.2 or 3.6 mm wide blade, then follow this cut with an extra wide blade of the desired width (5 to 20 mm) and only then use the 2-part Chamfer blade to bevel the outer edges
- The 2 blades allow for the insertion of spacers in-between, which enables bevelling to any width of cut
- To avoid the angled diamond segments from developing grooves and prematurely losing their bevel, increase or reduce the amount of spacers. By alternating the amount of spacers, the section of the diamond segments bevelling the concrete edge is being varied, which ensures the bevel on the blades is maintained till worn out.
- Simply raise or lower the machine (blade) height to accommodate the correct width of cut
- This blade is best operated on 20 - 27 HP machines and it is strongly recommended to use a jockey wheel at the front of the saw to eliminate the machine from dropping lower / deeper into the cut.
Price excl. GST $2395
excl. GST
Low stock
Specifications
- Size in mm
- 350.00
- Segment width
- 10.00
- Segment height
- 16.00
- Machinery
- Floor Saw - LP - from 13HP
- Standard Bore
- 25.4 + pin
- Weld
- Brazed
- Application
- Wet & Dry
- Quality
- Premium
Mix & Match
Loading
FSL-CA★★★ CHAMFER | floor saw blade | 350x10x16 (2pc)
Item No. DFS0350-CHAM-01
- 2-part Chamfer diamond blade for bevelling concrete, asphalt and green concrete
- Not designed to perform cuts but to bevel existing cuts only
- The ideal procedure is to pre-cut with a standard 3.2 or 3.6 mm wide blade, then follow this cut with an extra wide blade of the desired width (5 to 20 mm) and only then use the 2-part Chamfer blade to bevel the outer edges
- The 2 blades allow for the insertion of spacers in-between, which enables bevelling to any width of cut
- To avoid the angled diamond segments from developing grooves and prematurely losing their bevel, increase or reduce the amount of spacers. By alternating the amount of spacers, the section of the diamond segments bevelling the concrete edge is being varied, which ensures the bevel on the blades is maintained till worn out.
- Simply raise or lower the machine (blade) height to accommodate the correct width of cut
- This blade is best operated on 20 - 27 HP machines and it is strongly recommended to use a jockey wheel at the front of the saw to eliminate the machine from dropping lower / deeper into the cut.
Low stock
Price excl. GST $2395
excl. GST
Specifications
- Size in mm
- 350.00
- Segment width
- 10.00
- Segment height
- 16.00
- Machinery
- Floor Saw - LP - from 13HP
- Standard Bore
- 25.4 + pin
- Weld
- Brazed
- Application
- Wet & Dry
- Quality
- Premium